Is your chainsaw beginning to seem dull and not carry out as well? Looks like it's time to replace the chain. In order to do this, you will have to have to know the length of both the chainsaw blade as well as the length and size of your chain. If you have checked out the manufacturers' charts, they may seem a tiny overwhelming. But it extremely is pretty straightforward once you fully grasp what's involved in the length of the blade and chainsaw chain.
When you're prepared to replace your chain, the 1st thing to do is ascertain the size of your chainsaw bar. If you happen to have an Oregon chainsaw, this really should be uncomplicated. Just check the to begin with two numbers of the ten-digit model quantity that is stamped on the motor finish of the blade. That is your chainsaw bar length.
Do not have an Oregon chainsaw that conveniently shows you the length of the blade? Then right here are some suggestions for figuring it out oneself.
What is The Very best Way To Measure A Chain Saw Blade?
To measure the chainsaw blade itself is straightforward adequate to do. Just put your measuring tape at the finish of the bar up against the casing and measure straight down the bar all the way to the tip of the blade.
Blade and bar are two terms that are each used to indicate the identical item. This is the blade that extends from the casing of the motor and carries the chain which is what does the sawing for you.
Manufacturers were sort enough to standardize the chainsaw blade lengths into two-inch increments. The most normal sizes are 16, 18, and 20 inches even though the full range goes from 10 to 42 inches! When you measure your blade, round up to the nearest 2-inch measurement if needed.
Measuring A Chainsaw Chain
To measure the chain on your chainsaw, there are two issues you will need to know ... the quantity of drive hyperlinks and the pitch of the chain.
A drive link is just a tooth on the chain and your chain's length is determined by the quantity of drive hyperlinks (or teeth). The pitch of the chain also affects the size of the drive hyperlinks.
The pitch of the chain is necessary to know as it have to match the pitch of both the drive sprocket as well as the bar nose sprocket. This should be stamped on the drive link but if you will need to measure the pitch yourself, take the distance in between any three rivets of the chain and divide by 2.
As an example, a 1/4" pitch chain may possibly have 52 drive hyperlinks and be 2.17 feet in length, though a 3/8" pitch with 52 drive hyperlinks would be three.18 feet in length. So the pitch affects the drive link size which impacts your blade's length.
Nonetheless unsure? Just check with your chain saw's manufacturer or any person who makes chains and they will be in a position to clear up any confusion you can have.
